Harley Davidson Engine Temperature Sensor Location

A cam position detector can provide information about the position of the engines camshafts when setting the ignition to ensure perfect timing.

Harley davidson engine temperature sensor location. It is accessible by removing the horn. 2014 Harley Davidson Electra Glide Coolant Temperature Sensor Replacement. I cant not imagine that replacing a failed temp sensor would make a negative impact on the way the bike runs unless some sort of adjustment was made beforehand to compensate for the failed sensor.

2014 Harley Davidson Electra Glide Coolant Temperature Sensor Replacement - YouTube. On a fuel injected Harley if you suddenly need to add throttle to start the engine this is a common sign of a failing MAP sensor. Continue the wire harness up the right-side frame tube and through the P-clamp located near the steering head.

If the engine doesnt act up in the same amount of time its a good bet the sensor is failing. Turorial Video-Harley-Davidson Engine Idle Temperature Management System-EITMS. Locate the sensor away from the engine heat and start the engine and run it untill its hot.

Check Engine Light or trouble code. A check engine light will appear if the sensor fails or if certain trouble. The temp sensor is located at the back of the front cylinder behind the horn.

For you motorcycle guys new to my channel. The IAT sensorintake air temp sensor does just what it says it measure the intake air temperature and sends this signal to the computer this is actually a minor input signal the more important one is the engine coolant temp sensor the computer looks for a large deviation between the two sensors mainly when the engine is coldif the temperatures are within a certain window the computer gives the ok to start the engine both sensors are input to the ECM but the IAT temp. Different modes allow for use as a Speedomete.

The bike now runs like it did before the sensor went bad. On the M8s it is on the front right of the rear cylinder head. On the TCs the temp sensor is on the left rear of the front cylinder head.